粉化等级检测标准

发布时间：2023-02-15 03:07:56 • 阅读量： • 来源：中析研究所

粉化等级检测标准相关信息

GB/T 30789.7-2015 色漆和清漆涂层老化的评价缺陷的数量和大小以及外观均匀变化程度的标识第7部分:天鹅绒布法评定粉化等级
简介：GB/T 30789的本部分规定了一种粉化等级的评定方法,尤其适用于粗糙表面上的白色或其他色漆涂层和多涂层体系(例如,粗糙度大于ISO 8503-1规定的粗糙度比较样块G中的第4段)粉化等级评定。本部分规定的方法也可用于光滑表面上的涂层和多涂层体系粉化等级的评定,但ISO 4628-6规定的方法更适合。本试验方法适用于矿物基材上的涂层和多涂层体系,如:纤维水泥板、砖块、混凝土和底层灰浆,测试不受表面结构的影响。经验丰富的操作人员使用本方法很有效,可用于实验室及现场评定。ISO 4628-1定义了用于涂层老化缺陷的数量和大小以及外观均匀变化程度的标识,并概述了评定体系的通则。本评定体系特别适用于老化引起的缺陷和一般类型的破坏,如颜色变化、黄变等。
信息：ICS：87.040 CCS：G50 发布：2015-05-15 实施：2015-10-01

GB/T 30789.6-2015 色漆和清漆涂层老化的评价缺陷的数量和大小以及外观均匀变化程度的标识第6部分:胶带法评定粉化等级
简介：GB/T 30789的本部分提供了评定色漆涂层粉化程度的图片参照标准。本部分也规定了评定粉化等级的方法。使用本方法时,重要的是仔细区分真正的老化降解产物和沾污物,尤其是轻微粉化时。
信息：ICS：87.040 CCS：G50 发布：2015-05-15 实施：2015-10-01

DIN EN ISO 4628-7-2016 色漆和清漆.漆膜降解的评定.缺陷量值、大小以及外观均匀改变程度的规定.第7部分:粉化等级评定用丝绒方法(ISO 4628-7-2016).德文版本EN ISO 4628-7-2016
简介：
信息：ICS：87.040 CCS：G50 发布：2016-07 实施：

BS EN ISO 4628-7-2016 涂料和清漆.漆膜降解的评定.缺陷的量值和大小以及外观均匀变化强度的规定.用丝绒法评定粉化等级
简介：
信息：ICS：87.040 CCS：G50 发布：2016-02-29 实施：2016-02-29

KS M ISO 4628-7-2011 涂料和清漆.漆膜降解的评定.缺陷量值、大小和外观均匀改变程度的规定.第7部分:用丝绒法评定粉化等级
简介：이 표준에서는 표면이 거친[예를 들면 거칠기가 KS M ISO 8503-1에 기술된 기준
信息：ICS：87.040 CCS：G50 发布：2011-12-28 实施：2011-12-28

ISO 4628-6-2011 涂料和清漆.涂层降解的评定.缺陷数量和大小及外表均匀变化强度的规定.第6部分.用胶带法评估粉化等级
简介：
信息：ICS：87.040 CCS：G51 发布：2011-08 实施：

SANS 4628-6-2007 色漆和清漆．涂层降解性的评定．表面缺陷数量和大小和均匀变化强度的测定．第6部分：用粘胶带法评估粉化等级
简介：Provides pictorial reference standards for designating the degree of chalking of paint coatings. Also describes a method by which the degree of chalking is rated.
信息：ICS：87.040 CCS：G51 发布：2007-12-07 实施：

DIN EN ISO 4628-6-2007 涂料和清漆.涂层降解的评估.缺陷的数量和大小及外表一致变化饱和度的标识.第6部分:用粘胶带法评估粉化等级
简介：This part of ISO 4628 provides pictorial reference standards for designating the degree of chalking of paint coatings . It also describes a method by which the degree of chalking is rated . In using this method. It is essential that care be taken to destinguish between true degradation products and adhering dirt,particularly when chalking is slight.
信息：ICS：87.040 CCS：G51 发布：2007-11 实施：

BS EN ISO 4628-6-2007 涂料和清漆.涂层降解的评定.缺陷数量和大小及外表均衡变化强度的标识.用粘胶带法评估粉化等级
简介：This part of ISO 4628 provides pictorial reference standards for designating the degree of chalking of paint coatings. It also describes a method by which the degree of chalking is rated. In using this method, it is essential that care be taken to distinguish between true degradation products and adhering dirt, particularly when chalking is slight.
信息：ICS：87.040 CCS：G51 发布：2007-09-28 实施：2007-09-28

ISO 4628-6-2007 涂料和清漆.漆膜降解的评定.缺陷的量值和大小以及外观均匀变化强度的规定.第6部分:用胶带方法评定粉化等级
简介：This part of ISO 4628 provides pictorial reference standards for designating the degree of chalking of paintcoatings. It also describes a method by which the degree of chalking is rated. In using this method, it isessential that care be taken to distinguish between true degradation products and adhering dirt, particularlywhen chalking is slight.
信息：ICS：87.040 CCS：G50 发布：2007-02 实施：

NF T30-071-7-2004 色漆和清漆.漆膜降解的评价.缺陷量值、大小以及外观均匀变化程度的规定.第7部分:用丝绒法评定粉化等级
简介：
信息：ICS：87.040 CCS：G50 发布：2004-04-01 实施：2004-04-20

DIN EN ISO 4628-7-2004 色漆和清漆.漆膜降解的评定.缺陷量值、大小以及外观均匀改变程度的规定.第7部分:粉化等级评定用丝绒方法
简介：
信息：ICS：87.040 CCS：G50 发布：2004-01 实施：

BS EN ISO 4628-7-2003 涂料和清漆.漆膜降解的评定.缺陷的量值和大小以及外观均匀变化强度的规定.用丝绒法评定粉化等级
简介：This part of ISO 4628 describes a method suitable, in particular, for rating the degree of chalking on white or coloured exterior coatings and coating systems on rough surfaces (i.e. those having a roughness greater than segment 4 of reference comparator G as described in ISO 8503-1). The test method specified may also be used for the assessment of the degree of chalking of coatings and coating systems on smooth surfaces, but the method specified in ISO 4628-6 is preferable for this purpose. The test method is applicable to coatings and coating systems on mineral substrates, e.g. fibre cement, brick, concrete and renderings, independent of the structure of the surface. The method can be used quite effectively by experienced operators and is recommended for laboratory use as well as for on-site evaluation. NOTE 1 When a reference to this test method is included in specifications, the test conditions (i.e. weathering method and substrate) should be agreed between the interested parties. NOTE 2 The method described in this part of ISO 4628 is a relative ranking method and is therefore not suitable for use in agreements between parties. See, however, the Note to Table 1. ISO 4628-1 defines the system used for designating the quantity and size of defects and the intensity of changes in appearance of coatings and outlines the general principles of the system. This system is intended to be used, in particular, for defects caused by ageing and weathering, and for uniform changes such as colour changes, for example yellowing.
信息：ICS：87.040 CCS：G50 发布：2003-10-07 实施：2003-10-07

EN ISO 4628-7-2003 色漆和清漆.漆膜降解的评定.缺陷的量值和大小以及外观均匀变化强度的规定.第7部分:用丝绒法评定粉化等级 ISO 4628-7-2003
简介：
信息：ICS：87.040 CCS：发布：2003-09-01 实施：

ISO 4628-7-2003 色漆和清漆.漆膜降解的评定.缺陷量值、大小以及外观均匀变化程度的规定.第7部分:用丝绒法评定粉化等级
简介：This part of ISO 4628 describes a method suitable, in particular, for rating the degree of chalking on white or coloured exterior coatings and coating systems on rough surfaces (i.e. those having a roughness greater than segment 4 of reference comparator G as described in ISO 8503-1).The test method specified may also be used for the assessment of the degree of chalking of coatings and coating systems on smooth surfaces, but the method specified in ISO 4628-6 is preferable for this purpose.The test method is applicable to coatings and coating systems on mineral substrates, e.g. fibre cement, brick, concrete and renderings, independent of the structure of the surface. The method can be used quite effectively by experienced operators and is recommended for laboratory use as well as for on-site evaluation.NOTE 1 When a reference to this test method is included in specifications, the test conditions (i.e. weathering method and substrate) should be agreed between the interested parties.NOTE 2 The method described in this part of ISO 4628 is a relative ranking method and is therefore not suitable for use in agreements between parties. See, however, the Note to Table 1.ISO 4628-1 defines the system used for designating the quantity and size of defects and the intensity of changes in appearance of coatings and outlines the general principles of the system. This system is intended to be used, in particular, for defects caused by ageing and weathering, and for uniform changes such as colour changes, for example yellowing.
信息：ICS：87.040 CCS：G50 发布：2003-09 实施：

ISO 4628-6-1990 色漆和清漆漆膜降解的评定一般性缺陷程度、量值和大小的规定第6部分:粉化等级评定用胶带方法
简介：ISO 4628 is a series of standards dealing with the sampling and testing of paints, varnishes and related products. This part provides pictorial reference standards for designating the degree of chalking of paint coatings. It also describes a method by which the degree of chalking is rated. In using this method, it is essential that care be taken to distinguish between true degradation products and adhering dirt.
信息：ICS：87.040 CCS：G50 发布：1990-12 实施：